RGB LED strip light is the most commonly used light for decoration, and you can see it everywhere, especially when it is festival, performance, party, or event. This passage will show you some factors that may cause damages of the strip light to allow you to make full use of this strip light.
If the packaging protection of the strip light is not perfect, it may cause collision and damage of the lamp bead in the process of transportation, greatly affecting the performance of the strip light. If there is virtual phenomenon of welding points, transport vibration may cause the falling off of the solder joints and the light may not be bright. It is obvious that the packing and welding of the strip light matter a lot to the performance of the strip light. Therefore, to make the strip light work well, you must pay close attention to the packing and welding of the strip light.
If the soldering quality of the RGB LED strip light is bad, it may cause the falling off phenomenon of the solder joint in the process of bending. If the bending angle is too large when installation, it may result in the separation of solder joint and copper foil and the strip light will not light. It is easy to see that the soldering and bending must be paid attention to.
If the strip light is excessively extruded when installed, it can result in the great damage of the light chip damage or the deformation of solder joints, having bad effects of the strip light. For the installation of the strip light, it is suggested that the strip light should not be distorted as the distortion will cause the falling off of the solder joints and cause it not bright of the strip light.
Until now, you can know what may cause damages of the RGB LED strip light from the above. By knowing the above information, you are allowed to know how to make the most of the strip light and avoid the occurrence of the bad light effects.